This product is custom-made. No returns or exchanges.
12 x output (C13) on the device
Switchable via HTTP, command line tool or RS-232
2 x energy meter per 6 x output port, one measures continually, one can be reset
Measures current; voltage; phase angle; power factor (cos phi); frequency; active, reactive and apparent power
Per input, one large LED screen displaying total current, IP address, sensor values and errors
Switching state and delay (0...9999 seconds) can be set for every output after power outage
Simultaneous activation of multiple power ports prevented by automatic latency time of 1 second
Twin Mode (2-port grouping)
Programmable on/off sequence
12-channel watchdog, each output can be assigned its own (ICMP/TCP) watchdog
2 x independent 230 V input for one or two phases
Built in surge protection for devices and load (L-N10 kA)
Firmware updates can be installed during operation via Ethernet
Supported protocols: HTTP 1.1, E-Mail, DHCP, SNMPv1 (Traps), SNMPv2c (Traps), Syslog, IPv6
Access protection with IP access control and/or optional password
Connectors: Input: 2 x IEC C20 male (max 16 A, 230 V), Output: 2 x 6 IEC C13 females, 1 x RJ45 female (network), 1 x DB9 female, 2 x RJ45 female (for optional sensors)